It can be used both before and after sanding the parquet for small repairs of strips that are not perfectly glued to the substrate.
HOW TO USE:
Make a small hole in the tablet where it is not firmly glued.
Ambientate the product before use. Inject 2-3 drops of water under the wooden elements to be fixed, possibly in correspondence with the joint. After 2 minutes, inject a small dose of POLY 1 on the same point. Be careful not to put an excessive amount of POLY 1 because during the hardening phase it swells, excessively increasing its volume. POLY 1 is a product that adheres tenaciously to the paint. Before gluing, always check the humidity of the screed which must be <2% (<0.5% anhydrite). Room temperature from 15 to 25°C, relative humidity not exceeding 75%. Always use adequate individual protection systems. Always consult the technical and safety data sheet of the product.
With this characteristic of swelling POLY 1 fills the voids solidly fixing also the tablets near the defective area. Immediately close the container once opened as the product hardens with air humidity. Never use wet containers.
Appearance: Viscous liquid
Viscosity (@20°C; Brookfield): 1000 – 5000
Yield Depending on use and thickness applied
Workability time (minutes) 10 – 15
Use temperature (°C): +15 - +25
Walkability (hours): 3 – 4
Film hardening (hours): 12 - 24 hours (depending on use and applied thickness)
Application/Tools: Special dropper (syringe) Tool cleaning: SE, with the product still fresh
Storage (months): 6
temperature between +5°C and +25°C
Disposal information Dispose of in accordance with applicable local and national regulations
Packaging: Jars with spout of 500 ml.
Limitations of use: Place the product at 20°C before application Protect from frost Once opened, the product has a natural tendency to harden Always use adequate individual protection systems
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.