RASAFOND
art. RAFO
10L can
BINDER RESIN FOR SMOOTHING WOODEN FLOORS
Quick-drying solvent-based binder resin for smoothing and grouting wooden floors; mixed with wood dust obtained from the finest sanding.
HOW TO USE:
APPLICATION
Ambientate the product before use. The product should be mixed in a 1:1 ratio approx. until obtaining a homogeneous mix with fine powder obtained by sanding the substrate to be treated. Spread the product with a smooth stainless steel trowel (American), apply the mixture obtained in the cracks or, better yet, skim the floor completely. If necessary, repeat the operation several times. After drying (about 40 - 60 min in NC) sand with fine abrasive paper to completely remove the dried product residues. Always check the humidity of the wood from 8 to 12%, the room temperature from 15 to 25°C and the relative humidity not exceeding 75%. Always use adequate individual protection systems. Always consult the technical and safety data sheet of the product.
NOTE
The incomplete removal of the excess binder can cause a different tone of the floor after painted. At this point you can proceed with the painting cycle. It is advisable to prepare the mix at the time of use to avoid differences in grouting shades.
SPECIFIC CHARACTERISTICS :
Appearance: Viscous liquid
Viscosity (@20°C; Brookfield): 900 – 1100
Yield (g/m2): depending on the substrate to be treated
Walkable (minutes): 15 – 30
Commissioning (minutes): 40 – 60
Working temperature (°C): +15 - +25 Application/Tools: smooth stainless steel trowel (American)
Tool cleaning: SE, with the product still fresh
Storage (months): 6
temperature between +5°C and +25°C
Disposal Information: Dispose of in accordance with applicable local and national regulations
Packaging: 10 l drums
Limitations of use: Flammable Do not apply in humid environments Ventilate the environment during application, avoiding drafts Always use adequate individual protection systems Given the large variety of wood species on the market it is always advisable to carry out tests to verify any variations shade of the wood to be treated. Set the product at 20°C before applying Solvent base
