Description
BINDER RESIN FOR SMOOTHING WOODEN FLOORS
Quick-drying solvent-based binder resin to be mixed with wood dust for grouting and smoothing
of the parquet.
5 liter can
TECHNICAL FEATURES:
- Single component
- Colorless
- High performance (filling properties)
- Quick sandability
- Overpaintable with water or solvent based products
APPLICATION AREA:
- Solid wood floors without interlocking 10 mm
- Mosaic parquet flooring
- Laminated solid wood floors (industrial)
- Solid wood floors with m/f joint
DO NOT USE:
- On non-absorbent substrates
- On materials other than wood or on already painted pre-finished floors
SUBSTRATE PREPARATION
Previously sand the parquet to obtain a smooth surface free from oils, greases and waxes.
APPLICATION
Ambient and shake the product thoroughly before use. Apply at room temperature between 10°C and 30°C. The product
it should be mixed in an approximately 1:1 ratio until a homogeneous mixture is obtained with fine powder derived from sanding the substrate to
to deal.
Given the great variety of wood essences available on the market, it is always advisable to carry out tests to verify any variations
of hue.
Then spread the product with a smooth notched stainless steel trowel (American) making the mix penetrate the cracks or better
still perform a complete mowing of the floor. If necessary, the operation can be repeated several times.
Once dry (after about 40 – 60 minutes) sand the surface with fine sandpaper to completely remove the residues
of dried product. Incomplete removal of the excess binder can cause differences in the tone of the floor after finishing
painting.
When the product is still fresh, remove any residual binder from the spatula using a cloth soaked in our SOLVENT
GR7. Once hardened, LEGASTUCCO L 100 can only be removed mechanically. Then paint using our products
one or two component water or solvent based paints.
Always use adequate individual protection systems. Before use Before use, always consult the technical and safety data sheet
of the product.