Description
Code 502224
VERMEISTER ZERO BICOMPONENT GLUE X PARQUET 10 KG ECO
Two-component, solvent-free, polyurethane glue for wooden floors
VERMEISTER ZERO %
of the latest generation suitable for laying on substrates of any kind, including radiant ones.
10 kg drum (9+1)
TOTALLY HYPOALLERGENIC
DESCRIPTION:
Solvent-free and water-free two-component epoxy-polyurethane adhesive for gluing wooden floors of any size on cement substrates, even radiant, and non-absorbent (ceramic, stoneware, marble...).
it is also ideal for laying pre-finished parquet. ZERO% represents the evolution of the REPOX adhesive and for this reason, in addition to being solvent-free, it also has a general improvement in the performance profile. Significantly improved are the elasticity, the tensile strength (both longitudinal and perpendicular to the plane), the yield and the workability.
To obtain effective and long-lasting bonding, the substrate must meet the following requirements:
- Humidity less than or equal to 2% measured in depth with a carbide hygrometer.
- Absence of hygroscopic lightening materials in the screed and adequate insulation if these materials are contained in the underlying layers.
- Adequate surface finish, not too "coarse" and not too smooth.
- Absence of inconsistent or dusty parts.
- Absence of loose cracks or other obvious defects.
Before carrying out the installation it is also necessary to check that the humidity of the wood is in balance with that of the environment. Shake component B and pour it into component A, mix carefully with an electric stirrer.
Apply ZERO% with the appropriate notched trowel, taking care to "work" the adhesive in order to incorporate any impurities from the substrate which could cause detachments. Lay the planks applying strong pressure and "beating" them to optimize their adjustment.
Do not wet the tops of the tablets with ZERO% but use, for this operation, a single-component vinyl glue (REVIN series).
Also in this case it is absolutely to avoid gluing on the sides. For installation on pre-existing floors? necessary to proceed with degreasing and roughening with the appropriate metal discs.
For laying on anhydride screeds it is necessary to remove the surface layer of the screed with abrasive discs (16 or 24 grain), remove the dust and complete the treatment with PRIMER UR50. Before sanding and finishing the floors, it is necessary to wait, under normal conditions, at least 3 days. This time can increase according to many factors (ambient temperature and humidity, essence...).
Although ZERO% does not contain water, it is necessary to measure the humidity before finishing. of the wood which must be in balance with that of the environment and in any case between 8 and 12%.
Precautions for use: refer to the relative safety data sheet.
Apply at temperatures between +10 and +30°C!
Chemical - Physical characteristics At 20°C
- In original unopened containers stored in a cool, dry place
APPLICATION:
The data contained in this sheet reflect our best knowledge but do not constitute a supply specification given the multiplicity of uses and application conditions.
TECHNICAL FEATURES:
Catalysis ratio: two-component solvent and water free
Application temperature: 15°
Application: No. 5 notched trowel
Open time: 1.30 hours
Total hardening: 36/48 hours
Yield: 1000gsm
Colour: oak - walnut
Stability: VERY HIGH
Cleaning: thinner
